On each Den device, there is a Setup LED that will show you specific patterns during adoption and factory reset. The signals are the same on each device, regardless if it’s a Hub or Den Smart Socket.
The only exception is our Den Remote that has another status LED which shows you if a command has been received by the network.
When prompted in the App, press and hold the setup button on your Den device for approximately5 seconds. The setup LED will begin to flash until the connection is established.
Press and hold the setup button on your Den device for approximately 10 seconds. The LED light will start blinking after 5 seconds then it will turn solid. Just keep holding for the full length of the 10 seconds.
The status LED on your Den Remote will flash 3 times when a command has been received by the Den network.
Command has not been received
The status LED on your Den Remote will flash 1 time when a command has not been received by the Den network.